Matt Coplon had some questions about some of the very specific tools that Dave Fisher, Profile’s head machinist, use’s when it comes to measuring hub shell bores.
Related
S&M – FACTORY FRIDAY – FORK IT OVER
Bending, measuring, cutting, more measuring, welding… get an over-the-shoulder view of the process from a straight tube to a set of S&M Widemouth forks. Also peep new Dagger frame colors, […]
DIRT WORLD FLY PARK – PRO BMX FINALS
DAVE MCDERMOTT IN “POST TIME”
The most popular riders today put out daily instagram clips but Dave McDermott is over here filming one perfectly nuanced video part every 12 years. It’s funny actually how well […]
The Road 2 Recovery – Episode 2- Scotty Cranmer
CLICHÉ CREW – ‘CLICHÉS OF BERLIN’
The Cliche´crew is back with another banger of a video. It’s always dope to see Linda Grabner, Anahi Valentina, Francina Fernandez, Wibke Vogel, and Emma Finnegan get together and wreck […]
S&M – 9ACRES EPISODE 5 – MEANHORSE RIDES AGAIN
Nathan “Meanhorse” Saunders is real nice with it… and the NZ GOAT-Father brings his bleeaaattt to the PA Trails in this August ’24-filmed installment of 9 Acres. In this episode, […]
COLD CUTS BLVD – KINK
RAW CUT – 41 YEAR OLD BMX LEGEND – RYAN NYQUIST “40/41” – HARO BIKES
Raphael Jeroma-Williams – Raw 2023
Raphael has a good eye for setup use. This raw video shows you a lot of the work that went into his section for Coppin It Sweet. Video by Stewart […]










1 thought on “Inside Profile Racing – Using Gauge Blocks to Measure our Hub Bores”